Back to top

2019 Custom Cutter

Tarzana, United States

$79,900

Hull is complete.  Beautiful interior.  Needs mast, sails, rigging, etc. and new owner.  Cost of a new 50' cruising yacht 500k +,

this vessel complete would be closer to 200k.  Call Jim 310-562-9802 for more details

Basic Boat Info

Price: $79,900
Boat Name: Endless Sea
Make: Custom
Model: Cutter
Year: 2019
Condition: New
Category: Sail
Construction: Steel
Keel Type: Fin Keel

Dimensions

Length: 50 ft
Length Overall: 47'9 ft
Waterline Length: 43 ft
Beam: 14 ft
Min Draft: 6 ft
Displacement: 35,007 lb
Ballast: 12,401 lb

Engines / Speed

Engines: 1
  • Make: Yanmar
  • Fuel: Diesel
  • Engine Power: 75hp
  • Type: Inboard
  • Year: 2019
  • Engine Location: Center
Maximum Speed: 9.1 kn
Displacement Type: Half Load

Tanks

Fuel Tanks: 1
Fuel Tank Capacity: 250 gal
Water Tanks: 1
Water Tank Capacity: 262 gal

Other

Heads Count: 2
Boat Class: Cutter, Cruisers

Contact

Jim Foyer
Some folks have lots of yachts Others have the hots for yachts I cater to both....
California Yacht Company

Office

Marina del Rey Yacht Sales
13763 Fiji Way, E4
Marina del Rey, California, US, 90292
Tel:(310) 562-9802
Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.


Additional Information

Equipment listed below is unused unless otherwise specifed.

  • Yanmar 75 hp Engine
  • Yanmar Controls
  • Edson Helm /attached controls to rudder
  • Danforth Compass
  • Flojet water pressure system
  • B&G speed, temp transducers & sensors
  • B&G depth sensor and transducer
  • VHF/FM radio 25 watt
  • Garmin GPS plotter
  • Refrigerator condensing unit
  • Sankyo Compressor (used)
  • Flowjet washdown pump
  • Aft swim step shower
  • Water heater
  • Microwave oven
  • Barient Winches: all self tailing
  •        2 mod 32 Large 2 speed
  •        2 Mod 24-45 2 speed
  •        2 Mod 31-30  2 speed
  •        2 Mod 17
  • ANCHORS  
  •        75lb Danforth
  •         45lb CQR plough (used)
  •          22lb Bruce
  •          3/4 ton Puller
  • Achilles 2-3 person Dinghy
Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

$
%
$
Disclaimer This calculator is intended solely for general informational purposes, and to provide a rough estimate based on the information you provide. You should not base your decision on this estimate alone.